Wolf ICBDD30 Instalační příručka stáhnout pdf (Strana 3)

wolfappliance.com

SPECIFICATIONS

Electrical

Installation must comply with all applicable electrical codes

and be properly grounded (earthed).

Locate the electrical supply as shown in the illustrations on

pages 3–4. A separate circuit, servicing only this appliance

is required. A ground fault circuit interrupter (GFCI) is not

recommended and may cause interruption of operation.

Certain installations may require that the electrical supply

be placed in an adjacent cabinet.

ELECTRICAL REQUIREMENTS

DOWNDRAFTS

Electrical Supply 220-240 V AC, 50 Hz

220 V AC, 60 Hz

Service 10 amp dedicated circuit

Receptacle grounding-type (earthed)

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of an elec-

trical short circuit, grounding reduces the risk of electric

shock by providing an escape wire for the electric current.

This appliance is equipped with a cord having a grounding

wire with a grounding plug. The plug must be plugged into

an outlet that is properly installed and grounded.

WARNING

Improper grounding can result in a risk of electric

shock. Consult a qualiﬁed electrician if the grounding

instructions are not completely understood, or if

doubt exists as to whether the appliance is properly

grounded.

Do not use an extension cord. If the power supply cord

is too short, have a qualiﬁed electrician install an outlet

near the appliance.

Installation Requirements

For installation with a Wolf cooktop, a minimum 638 mm

deep at countertop is required.

For installation with a sealed burner rangetop, an accessory

trim kit is required. Contact your authorized Wolf dealer for

details.

The remote-mounted control module can be positioned

horizontally or vertically. It must be located within 3 m of the

downdraft assembly and a minimum 76 mm from the edge

of the cooktop or rangetop cut-out.

BLOWERS

CAUTION

For use with Wolf 1014 m

/hr internal blower and

remote blowers rated maximum 3 amps.

Internal and remote blower assemblies are available through

your authorized Wolf dealer.

Internal blowers include a 152 mm round discharge, can be

front or rear mounted and can be discharged in any direc-

tion by rotating the blower box. Remote blowers have a 254

mm round discharge and can be discharged from the front

or rear.

DUCTWORK

Wolf downdrafts must be vented outside.

Consult a qualied HVAC professional for specic installa-

tion and ducting applications.

The downdraft will operate most efciently with the fewest

number of elbows and transitions and when ductwork does

not exceed 12 m.

FRONT VIEWSIDE VIEW

*152 mm back from countertop cut-out when internal blower is rear mounted.

NOTE: Internal blower 152 mm round, side, rear or bottom discharge. Remote blower 254 mm round, rear discharge.

Centerline indicates center of downdraft cut-out.

540

540 mm

210

mm*

COOKTOP CUT-OUT

68 mm

TOP VIEW

594 mm

210 mm*

DOWNDRAFT

CUT-OUT WIDTH

Downdraft

INSTALLATION WITH COOKTOP

CUT-OUT WIDTH

MODEL W

ICBDD30 699 mm

ICBDD36 851 mm

ICBDD45 1003 mm

1 2 3 4 5 6 7 8

Komentáře k této Příručce

Žádné komentáře

Wolf ICBDD30 Instalační příručka Strana 3

Komentáře k této Příručce

Související produkty a manuály pro ne Wolf ICBDD30