" (749).
Specifications for a warming drawer with integrated drawer front installed with a 36" (914) L Series single oven and
convection microwave with 36" (914) L Series trim.
COMBINATION INSTALLATION
The Wolf warming drawer with integrated drawer
front may be installed in combination with a
36" (914) L Series single oven and convection
microwave oven with 36" (914) L Series trim.
Refer to the illustration below for specifications.
IMPORTANT NOTE: Keep in mind that the width
of the custom panel for the warming drawer
with integrated drawer front will vary according
to the specific installation.
Wolf recommends using a 39" (991) wide
cabinet for this installation. Also, you need a
minimum 24" (610) of usable cabinet depth for
the oven.
IMPORTANT NOTE: Unless you are using
cabinets deeper than 24" (610), it is recom-
mended that the electrical supply for the built-in
oven be placed in an adjacent cabinet within
reach of the conduit.
The base platform for the warming drawer must
be able to support 200 lbs (91 kg), the platform
for the oven must be able to support 250 lbs
(113 kg) and the microwave platform must be
able to support 125 lbs (57 kg).
An anti-tip block or platform must be installed
to prevent the warming drawer from tipping
forward when the drawer is opened. The
warming drawer must be fully enclosed, top
and bottom.
For electrical requirements and additional specifi-
cations, refer to the built-in ovens and microwave
sections of our website, wolfappliance.com.
Also refer to the installation instructions
provided with the warming drawer front and
microwave trim kit for detailed specifications.
Komentáře k této Příručce