Wolf CTEWH45I Průvodce řešením problémů stáhnout pdf (Strana 10)

10

Blower connection at hood:

1)

Run conductors (2-wire plus ground) from

the in-line or remote blower to the hood's

wiring box marked "motor connection".

2)

Remove the cover from the wiring box and

remove one knockout as shown in illus 9.

3)

Secure the conduit to the wiring box

through a conduit connector.

4)

Make electrical connections at the hood.

Connect white-to-white, red-to-black and

green-to-ground.

5)

Replace the wiring box cover and screws.

make sure wires are not pinched between

the cover and box.

In-line or remote blower connection:

1)

Make electrical connections at the in-line or

remote blower. Refer to instructions

provided with the in-line or remote blower.

WOLF COOKTOP LOW-PROFILE HOODS

WALL HOODS – DUCTED

IN-LINE OR REMOTE BLOWER

Follow the installation steps for wall hoods on

pages 8–9. Additional wiring connections must

be made for the in-line or remote blower.

Installation instructions will be provided with

the remote blower.

WIRING

IMPORTANT NOTE:

The ventilation hood

must be properly grounded. It should be

installed by a qualified electrician in accor-

dance with all applicable national and local

electrical codes.

Complete the wiring procedure for the power

connection at the hood on the previous page,

then make the following connections.

Illus. 9

BOX MARKED

MOTOR

CONNECTION

REMOTE

BLOWER

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Komentáře k této Příručce

Žádné komentáře