Wolf Range Instalační příručka Strana 18

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 20
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 17
Gas Range Installation 18
Range Removal
If removal of the gas range is necessary for cleaning or
service, shut off the gas supply. Unplug the range and
disconnect the gas supply line. Remove the range. Rein-
stall in the reverse order and be sure to check gas
connections for leaks.
Refer to the Wolf gas ranges use & care guide for cleaning
recommendations.
Unplug the range and disconnect the gas supply line
before removing.
Verify Range Operation
IMPORTANT NOTE: P
rior to operating the range, be sure
to read the entire Wolf gas ranges use & care guide
included with the range for important safety, service and
warranty information.
SURFACE BURNERS
Place the burner parts on each burner base and position
the burner grates before lighting.
Surface burners of the gas range use electronic igniters.
When the control knob is pushed in and turned to the
HIGH position, the system creates a spark to light the
burner. This sparking continues until the electronic ignition
senses a flame.
To check operation of the surface burners, push in and
turn each control knob to the HIGH position. The flame
should light within four seconds.
If the burners do not light properly, turn control knobs to
the OFF position. Check that burner parts are in the
proper position. Make sure electricity is being supplied to
the range and that the gas shut-off valve is in the open
position. Check operation again, waiting at least five
minutes; if the burners still do not light properly, contact
Wolf factory certified service.
IMPORTANT NOTE: Initial lighting of the surface burners
may take slightly longer, as air in the system must be
purged before gas can be supplied to the burner.
OVEN OPERATION
Turn the oven(s) on and verify that they are coming up to
temperature. Refer to the Wolf gas ranges use & care
guide for additional information.
IMPORTANT NOTE: A small amount of smoke and odor
may be noticed during the initial break-in period.
Zobrazit stránku 17
1 2 ... 13 14 15 16 17 18 19 20

Komentáře k této Příručce

Žádné komentáře